---

Today I changed the flash plugs on my 95 Neon. When I pulled the firstly plug, the stop well was filled of oil. I cleaned it up and installed the recent plug. 2 of the different plugs were the same way. I tried to begin subsequently changing plugs, it only wont't run. I own recent stop wires on it, and am getting acceptable flash from the Dist. Mod. I own pulled the plugs back out some times and cleaned them off. They had unburned timber on them and a small oil. HELP PLEASE!!!!!! Answer:

---

the seals at teh summit of the flash tubes on the valve conceal are leaking. the oil leaks down from the summit all over the stop wires. when you removed the plugs all the oil fell down into the combustion chambers and is fouling the plugs. you should take the place of the valve conceal gasket and flash pipe selas so you don't destroy your recent wires. dirt teh plugs off again, and retry to begin it. if it won't go you can present it some throttle. you may own to go broad expose to put it into apparent run over mode, and permit off when it starts.




it shouldn't take all that a great deal to succeed to it started, while it depends on how a great deal you cranked on it before. the further you cranked on it the further flooded it got. if it still won't start, you power draw the plugs back out and permit it dry out over night.

---

are the wires stretched on the flash plugs and do you own flash beneath compression?

---

Oil on your plugs enjoy that is not a acceptable stain for your instrument while I dont believe thats your problem. Did you exchange the plugs only at a time? It sounds to me enjoy you may own crossed some stop wires. If so you determination require to come across the command that they go in (it determination greatest probable not go 1,2,3,4). After getting the wires in 0K firing command you should be acceptable to go. Also, did you break the plugs? That should not cause it not begin unless they are manner off while you should be sure they are at the correct gap.